Explainers
Cast iron cleaning methods compared
Hot water, nylon, salt, chainmail, and modern dish soap each solve different messes—none of them replace thorough drying, and the dishwasher is still the wrong default for bare iron.
In plain language
Cast iron cleaning methods are tools matched to soil: hot water and nylon for everyday film, coarse salt as a mild abrasive, chainmail for stuck bits, and syndet soap when food grease needs surfactants—while long wet cycles and dishwashers remain the main enemies of bare seasoning.
What this assumes: Routine care of bare seasoned iron at home; enamel and maker-specific finishes follow their own sheets; not a strip protocol (see the restore-safety hub for those paths).
Before you start
Match the scrubber to the mess, dry completely, and oil lightly when bare metal shows. Soap is usually fine on established seasoning; dishwashers are not.
Method comparison
| Method | Good for | Watch out |
|---|---|---|
| Hot water + soft scrub | Everyday food film | Leaving the pan wet afterward |
| Nylon scrubber | Stuck bits without gouging | Giving up too early and jumping to a strip |
| Coarse salt + oil/towel | Mild abrasion on fond | Grinding into soft, under-cured sticky coats |
| Chainmail scrubber | Baked-on bits on hardy seasoning | Over-scrubbing thin new films |
| Modern dish soap | Greasy residue on cured seasoning | Myth that any soap “deletes” polymerized oil instantly |
| Dishwasher | Almost never for bare iron | Wet alkaline cycles → stripped film + flash rust |
Soap myth vs practice
Ordinary washing and deliberate stripping are different jobs. Read soap vs seasoning for why modern syndet dish soap is not automatic seasoning death. If the surface is sticky and soft, fix the seasoning process with the sticky troubleshooting guide rather than scrubbing harder forever.
After you clean
Dry on low heat if needed, then a drop of oil on any bare patch. For dishwasher mistakes, see dishwasher and cast iron. Route broader care through the seasoning hub; for chemical strips after true failures, use the restore-safety hub and rust hub.
Is chainmail safe on cast iron seasoning?
On hardy, cured seasoning it can remove stuck food efficiently. On soft sticky coats, ease up and fix the seasoning process instead of abrading a half-cured film.
Should I use salt or soap?
Salt is a mild abrasive for fond; soap helps cut grease on cured seasoning. Many cooks use both across different messes. Neither replaces thorough drying.
Can I put cast iron in the dishwasher if I reseason afterward?
You can repair damage, but dishwashers are a poor routine. Prefer hand wash, dry, and oil—see the dishwasher guide.
Sources and scope
Educational home-kitchen guidance. Follow maker care sheets for your exact pan and cooktop. Not a laboratory protocol. Editorial policy.
Spot a questionable claim or a calculation issue? Read our correction process and contact information. Examples and illustrations are educational; they do not establish product suitability or a laboratory result.